There are two modes of editing available in the software:
- Pop-In Mode. In this mode you edit items on top of the main window. The advantage of this is that it allows you to see the items you are editing on top of other project items. It also allows you to align the new items you draw with the other project items.
- Pop-Out Mode. In this mode items are edited in a separate window and you do not see other project items behind it. Although this mode is generally less often used, it can sometimes be useful to isolate the items being edited, and remove needless clutter from the screen.
The controls that are available are the same regardless of the editing mode, although the layout of these controls is slightly different. The following three buttons are always present:
- OK. Clicking this button will apply to changes you have made to the project, and finish editing.
- Apply. Clicking this button will apply the changes you have made to the project, but allow you to continue editing. This button is not visible when editing site plans in In Screen mode, since you are already seeing the changes as applied.
- Cancel. Clicking this button will cancel the changes you have made to the project, and finish editing.
The following controls are used to switch between Pop-In and Pop-Out editing modes.
|
If you are using Pop-In mode you can click this icon at the top-centre of the screen to switch to Pop-Out mode. |
|
If you are using Pop-Out mode you can click this icon at the top-right of the screen to switch to Pop-In mode. |